Javascript Menu by Deluxe-Menu.com
Schenck Limited

HM 4 - HM 50

Horizontal Balancing Machines

  • Universally applicable
  • High balancing accuracy
  • Easy to upgrade through modular construction and a wide range of accessories
  • Hard-bearing principle ensures quick change-over from one workpiece to the next
  • CAB 700 or CAB 920 measuring instrumentation with extensive operator prompting
  • Full range of safety equipment for all protection classes

Range of application

Universal balancing machines series HM are conceived for highly precise balancing of a wide spectrum of rotors. They are suitable for balancing cylindrical rotors with integral shaft journals and for balancing disc shaped rotors on balancing arbors.

Permanent calibration, ergonomic design and a logical operating sequence facilitate operation.

Their modular design principle and a wide range of accessories make the machine highly flexible.

Schenck universal balancing machines series HM are a highly efficient investment both for one-off rotors and for small batches.

Sequence of operations

  • Manually load work-piece on the bearing pedestals, close hold-down bearings and connect drive (belt drive or drive shaft)
  • Close protection device and start automatic measuring sequence:
  • Acceleration, determination and display of the unbalance on the measuring instrument, braking. The readout is retained on the measuring instrument even after the measuring run has ended.
  • Open protection device, manually correct unbalance (if required).
  • Check correction result (with measuring instrument displaying whether the tolerance has been achieved) and unload the rotor from the machine.

Special features

  • Easy to operate – hard-bearing principle eliminates the need for calibration runs
  • Provides for correction in two planes or separate correction of static and couple unbalance
  • Rotors can be mounted on their original shafts or on mounting arbors, optionally with mounted anti-friction bearings
  • Angle indexing display in case of belt drive
  • Automatic measuring cycle with infinitely variable settings for acceleration, measuring and braking time
  • Upgradeable by many additional modules e.g. for mass correction
Further information
Arrangement plan
1 Balancing machine2 Controls and measuring device Plan view (non-binding example)
Contact

Paul Kearns

Phone
+44 (0)1926 47 40 90
E-Mail
Add to list of marked products

Use of cookies
Cookies enable the best possible provision of our services. By using our pages and services you agree that we use cookies.
Link to the Schenck RoTec data protection declaration

OK